How much rebar do I need for a 30×30 slab?
A 30 × 30 ft slab with #4 rebar on a 16 in grid takes 97 stock bars of 20 ft, which is 1,434 linear feet weighing about 958 lb. Tying the grid takes 529 ties and 2 rolls of tie wire, and holding it at mid-slab takes 300 chairs. At 12 in spacing for a driveway it is 126 bars; at 24 in for a light patio, 63.
Rebar for a 30×30 slab by grid spacing
| Grid spacing | 20 ft stock bars (5% extra) | Linear feet | Weight | Ties | Chairs |
|---|---|---|---|---|---|
| 12 in | 126 | 1,870 ft | 1,249 lb | 900 | 300 |
| 16 in | 97 | 1,434 ft | 958 lb | 529 | 300 |
| 18 in | 84 | 1,247 ft | 833 lb | 400 | 300 |
| 24 in | 63 | 935 ft | 625 lb | 225 | 300 |
#4 (1/2 in) rebar with 3 in edge clearance in a 30 × 30 ft slab. Runs longer than 20 ft include a 20 in lap at each splice.
Change the numbers
The calculator below is preset for this size. Adjust anything and the results update instantly.
Rebar or wire mesh for a 30×30 slab?
For a 4 in patio or shed slab, 6 × 6 W1.4 welded wire mesh is usually enough: 20 sheets of 5 × 10 ft, or 2 rolls of 5 × 150 ft. Mesh costs less and goes down faster but is hard to keep at mid-depth; it tends to end up on the ground where it does nothing. Rebar on chairs stays where you put it and is the right call for anything a vehicle drives on, a slab over 4 in thick, or a slab on clay or fill. For a garage or driveway, #4 at 12 in is common; for a workshop floor with heavy equipment, step up to #5 at 12 in, which for this slab is 97 bars weighing 1,515 lb.
Rebar cost and installation for 900 square feet
#4 rebar sells for about $0.70 to $1.00 per foot, or $14 to $20 per 20 ft stick, so the 97 bars for a 16 in grid cost $1,358 to $1,940. Chairs are about 25 cents each ($75) and tie wire a few dollars a roll. A rebar cutter or an angle grinder with a metal wheel handles the cuts; a pigtail tie tool makes the 529 ties go quickly. Keep the grid 3 in from any edge, splice with 20 in laps tied in two places, and stagger the splices. Size the pour itself with the concrete calculator for a 30×30 slab.
Common questions
How many pieces of rebar for a 30x30 slab?
23 bars running the 30 ft direction and 23 running the 30 ft direction at 16 in on center, for 1,434 linear feet. That cuts from 97 stock bars of 20 ft with 5 percent extra.
How much does rebar for a 30x30 slab weigh?
About 958 lb for #4 bar on a 16 in grid, or 1,249 lb at 12 in. #4 rebar weighs 0.668 lb per foot.
What spacing should rebar be in a 30x30 slab?
16 in on center for most residential slabs, 12 in for driveways and anything carrying vehicles, and 18 to 24 in for light-duty patios where wire mesh would otherwise be used. Keep it at mid-depth on chairs.